User's Manual

7 (15)
Section 4: THERAPY ACTIVITIES
1. Confirm patient’s avatar in VR space corresponds to actual patient’s physical
movement.
2. Confirm application audio can be heard but doesn’t block out HCP’s
communication; adjust volume on headset as needed.
3. Conduct rehabilitation session as planned. (See Section 6 which includes a
software description for details of therapeutic activities).
4. Always remain with the patient throughout therapy session to provide direct
supervision.
5. Monitor patient view on tablet; select and begin new activities as desired.
Note: If sensors lose synchronization or headset loses tracking, turn off entire system
then back on to reset. Headset is turned off and on using the power button. App
should be relaunched on the tablet. Sensors are turned off and on by placing them in
the powered charging station (while the REAL™ Immersive System is plugged in) and
removing them again.
6. When planned therapy activities are complete, press “End Session” on tablet.
Patient will be returned to the Hide and Seek activity.
7. View patient results on tablet. You may also switch to the Notes tab for a
summary of session and activity times.
Section 5: SYSTEM REMOVAL
1. Remove sensors and bands.
2. Remove headset from patient’s head.
3. Power off headset by pressing and holding onto the power button for
approximately 5 seconds.
4. Log out of tablet.
5. Clean headset and sensors with institutional approved sanitizing wipes*.
6. Ensure REAL Immersive System Case is plugged in.
7. Connect tablet and headset to their respective power cords.
8. Return all sensors to sensor charger. Red or green LEDs should be noted on
sensors when placed correctly in the charging station.
9. Store and label bands for future individual patient use.
10. Sufficiently charge all components after each use and prior to next use
for 60 minutes.
Note: Standard operation is to power cycle and relaunch application between therapy
sessions to reestablish system connections.
*Handle the lenses on the headset carefully to avoid smears or scratches. Wipe
lenses with a soft cloth for cleaning as needed. Clean outer and inner plastic