User's Manual
Table Of Contents
- All-In-One Headset with Software Application
- Headset Controller
- Large Sensor
- Small Sensors
- Sensor Charger (charging station)
- REAL Sensor Bands
- Headset
- Plug the headset power cord into wall outlet and the headset to charge device.
- Press power button to power on or off headset. The power button is on top of the headset.
- Headset Controller
- • Buttons on the controller are used to access settings.
- Sensor Charger
- Plug sensor charger power cord into wall outlet and sensor charger to power on device to charge sensors.
- Large Sensor and Small Sensors
- • Activate or charge sensor devices by removing or placing back into the sensor charging station.
- Place sensor devices into the sensor bands.
- Sensor Bands
- See Section 3 in Operating Procedures on instructions to put on sensor bands.
- User Portals
- Access the User Portal through the Headset to perform the following:
- o Logging in
- o Selecting the activity
- o Initializing and syncing to sensors
- o Starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- o Selecting the application
- o Logging in
- o Adding or selecting patient
- o Initializing and syncing to sensors
- o Selecting, starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
- SECTION 3: START UP
- USER:
- 1. Using a personal device, log into the user portal using your username and password.
- 2. Select the activity assigned by your therapist within the user portal
- Section 4: ACTIVITY NAVIGATION
- Section 5: SYSTEM REMOVAL
Page 12 of 29
HCP:
Patient Rehabilitation Activities:
1. Log into the HCP Portal and locate the patient profile.
2. Select the designated activity and click “Start Session”.
Patient Wellness Activities:
1. Log into the HCP Portal and locate the patient profile.
2. Review patient’s session results.
See Section 4 and 6 for more information.
Section 4: ACTIVITY NAVIGATION
User
1. Conduct rehabilitation session as planned. (See Section 6 which includes a software description
for details of therapeutic activities).
Note: If sensors lose synchronization or headset loses tracking, turn off headset then turn back
on to reset. Headset is turned off and on using the power button. Sensors are turned off and on
by placing them in the powered charging station (while the REAL System 2 is plugged in) and
then removing them again.
HCP
1. Conduct rehabilitation session as planned. (See Section 6 which includes a software description
for details of therapeutic activities).
2. Navigate to additional therapy activities by selecting the corresponding icon from the HCP
Portal. Once the activity is loaded, the HCP can press the “Start Activity” button to begin the
activity.
3. Always remain with the patient throughout therapy session to provide direct supervision.
4. Monitor patient view on the HCP portal; select and change activities as desired.