User's Manual
Table Of Contents
- All-In-One Headset with Software Application
- Headset Controller
- Large Sensor
- Small Sensors
- Sensor Charger (charging station)
- REAL Sensor Bands
- Headset
- Plug the headset power cord into wall outlet and the headset to charge device.
- Press power button to power on or off headset. The power button is on top of the headset.
- Headset Controller
- • Buttons on the controller are used to access settings.
- Sensor Charger
- Plug sensor charger power cord into wall outlet and sensor charger to power on device to charge sensors.
- Large Sensor and Small Sensors
- • Activate or charge sensor devices by removing or placing back into the sensor charging station.
- Place sensor devices into the sensor bands.
- Sensor Bands
- See Section 3 in Operating Procedures on instructions to put on sensor bands.
- User Portals
- Access the User Portal through the Headset to perform the following:
- o Logging in
- o Selecting the activity
- o Initializing and syncing to sensors
- o Starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- o Selecting the application
- o Logging in
- o Adding or selecting patient
- o Initializing and syncing to sensors
- o Selecting, starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
- SECTION 3: START UP
- USER:
- 1. Using a personal device, log into the user portal using your username and password.
- 2. Select the activity assigned by your therapist within the user portal
- Section 4: ACTIVITY NAVIGATION
- Section 5: SYSTEM REMOVAL
Page 14 of 29
3. Power off headset by pressing and holding onto the power button for approximately 2 seconds.
4. Clean headset and sensors with institutional approved sanitizing wipes*.
5. Connect headset to the power cord.
6. Ensure REAL System 2 sensor charger is plugged in.
7. Return all sensors to sensor charger. Red or green LEDs should be noted on sensors when placed
correctly in the charging station.
8. Store and label bands for future use.
9. Sufficiently charge all components after each use and prior to next use for 60 minutes.
NOTE: Standard operation is to power cycle and relaunch application between therapy sessions to
reestablish system connections.
*Handle the lenses on the headset carefully to avoid smears or scratches. Wipe lenses with a soft cloth
for cleaning as needed. Clean outer and inner plastic components of headset with institutionally
approved sanitizing wipe. Do not use petroleum-based compounds, acids, caustics, or chlorinated
solvents to clean or lubricate any parts. Use only water-based solvents for cleaning.
Section 6: THERAPY EXPERIENCE
The REAL™ Immersive System contains a variety of activities that incorporate clinically recognized,
existing therapeutic and functional exercises to facilitate motor and cognitive rehabilitation. Settings for
each activity will involve parameters such as turning on and off avatar features and environmental
factors. While using the REAL Immersive System, the HCP remains responsible for the patient’s safety
and the appropriateness of individual exercises including range of motion (ROM) attempted and any
other limb or joint limitations unique to that patient.
Therapy Activity 1: Hide and Seek