User's Manual
Table Of Contents
- All-In-One Headset with Software Application
- Headset Controller
- Large Sensor
- Small Sensors
- Sensor Charger (charging station)
- REAL Sensor Bands
- Headset
- Plug the headset power cord into wall outlet and the headset to charge device.
- Press power button to power on or off headset. The power button is on top of the headset.
- Headset Controller
- • Buttons on the controller are used to access settings.
- Sensor Charger
- Plug sensor charger power cord into wall outlet and sensor charger to power on device to charge sensors.
- Large Sensor and Small Sensors
- • Activate or charge sensor devices by removing or placing back into the sensor charging station.
- Place sensor devices into the sensor bands.
- Sensor Bands
- See Section 3 in Operating Procedures on instructions to put on sensor bands.
- User Portals
- Access the User Portal through the Headset to perform the following:
- o Logging in
- o Selecting the activity
- o Initializing and syncing to sensors
- o Starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- o Selecting the application
- o Logging in
- o Adding or selecting patient
- o Initializing and syncing to sensors
- o Selecting, starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
- SECTION 3: START UP
- USER:
- 1. Using a personal device, log into the user portal using your username and password.
- 2. Select the activity assigned by your therapist within the user portal
- Section 4: ACTIVITY NAVIGATION
- Section 5: SYSTEM REMOVAL
Page 2 of 29
•
All-In-One Headset with Software Application
• Headset Controller
• Large Sensor
• Small Sensors
• Sensor Charger (charging station)
• REAL Sensor Bands
The headset contains a power button that turns the component on or off and a charger/accessory port.
The headset also provides visual feedback of virtual reality applications in concert with the REAL System
2 small and large sensors.
Large and small sensors are equipped with mechanical and electrical components that measure motion
and direction in physical space and then translate that information into a virtual environment.
The sensor charger powers the sensors.
Headset controller can be used to perform administrative tasks such as connect to network, select
therapy activity, access settings, etc.
At full charge, the entire system can last at a minimum of 60 minutes and it is recommended that a
therapy session does not exceed 60 minutes. The expected amount of time to charge the system to last
the recommended therapy session time is 60 minutes.
In the event of Electromagnetic disturbances, the performance of the REAL System 2 may be affected.
The REAL System 2 is a Type BF Applied Part.
Frequently used features and functions:
Headset
• Plug the headset power cord into wall outlet and the headset to charge device.
• Press power button to power on or off headset. The power button is on top of the
headset.
Headset Controller
• Buttons on the controller are used to access settings.
Sensor Charger
• Plug sensor charger power cord into wall outlet and sensor charger to power on device
to charge sensors.