User's Manual
Table Of Contents
- All-In-One Headset with Software Application
- Headset Controller
- Large Sensor
- Small Sensors
- Sensor Charger (charging station)
- REAL Sensor Bands
- Headset
- Plug the headset power cord into wall outlet and the headset to charge device.
- Press power button to power on or off headset. The power button is on top of the headset.
- Headset Controller
- • Buttons on the controller are used to access settings.
- Sensor Charger
- Plug sensor charger power cord into wall outlet and sensor charger to power on device to charge sensors.
- Large Sensor and Small Sensors
- • Activate or charge sensor devices by removing or placing back into the sensor charging station.
- Place sensor devices into the sensor bands.
- Sensor Bands
- See Section 3 in Operating Procedures on instructions to put on sensor bands.
- User Portals
- Access the User Portal through the Headset to perform the following:
- o Logging in
- o Selecting the activity
- o Initializing and syncing to sensors
- o Starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- o Selecting the application
- o Logging in
- o Adding or selecting patient
- o Initializing and syncing to sensors
- o Selecting, starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
- SECTION 3: START UP
- USER:
- 1. Using a personal device, log into the user portal using your username and password.
- 2. Select the activity assigned by your therapist within the user portal
- Section 4: ACTIVITY NAVIGATION
- Section 5: SYSTEM REMOVAL
Page 5 of 29
At no time should liquid products be allowed near any device component.
No modification of this equipment is allowed.
Use of accessories, transducers, and cables other than those specified or provided by the manufacturer
of this equipment could result in increased electromagnetic emissions or decreased electromagnetic
immunity of this equipment and result in improper operation.
Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm (12 inches) to any part of the REAL System 2, including
cables specified by the manufacturer. Otherwise, degradation of the performance of this equipment
could result.
Use of this equipment adjacent to or stacked with other equipment should be avoided because it could
result in improper operation. If such use is necessary, this equipment and the other equipment should
be observed to verify that they are operating normally.
Accessories such as power adapters and cords should not be replaced by the end user and should only
be replaced by Penumbra. Any changes or replacements of accessories will likely impact compliance of
REAL System 2.
Use of this device should be in a secure information technology environment. Outbound https
communication channels must be open.
POTENTIAL ADVERSE EFFECTS/EVENTS
Visual stimulation through head-mounted displays have a small possibility of provoking an epileptic
seizure. Should this occur, stop using the device immediately. Other possible complications include, but
are not limited to, the following:
• claustrophobia
• discomfort or pain in the head or
eyes
• disorientation/vertigo/dizziness
• drowsiness
• eye strain
• falls or fractures
• headache/migraine
• insomnia
• light-headedness
• motion sickness
• nausea
• pain
• repetitive strain injury
• seizure
• skin irritation
• vision problems
Should any of the above occur, stop using the device immediately.
OPERATOR PROFILE
Intended users for this device are those with physical, neurorehabilitation and/or wellness needs. A
caregiver may be optionally present to help operate the system.
Healthcare provider (HCP) of the REAL
TM
System 2 prescribing rehabilitation activities should be trained
in rehabilitation therapy.