User's Manual

2 (15)
DEVICE DESCRIPTON
The REAL
® Immersive System is a digital hardware and software medical device
platform utilizing virtual reality technology designed for use in a clinical environment,
or any other facility that may facilitate rehabilitation, setting that focuses on physical,
neurorehabilitation and/or wellness needs.
REAL Immersive System consists of following components:
• All-In-One Headset with Software Application
• Headset Controller
• Large Sensor
• Small Sensors
• Tablet
• Sensor Charger (charging station)
• REAL Sensor Bands
Tablet is fitted with a touch screen, a power/lock key that turns the component on or
off, and a charger/accessory port.
The headset contains a power button that turns the component on or off and a
charger/ accessory port. The headset also provides visual feedback of virtual reality
applications in concert with the REAL Immersive System tablet and small and large
sensors.
Large and small sensors (WTM and WSMs) are equipped with mechanical and
electrical components that measure motion and direction in physical space and then
translate that information into a virtual environment.
The sensor charger powers the sensors.
Headset controller (Only to be used in certain troubleshooting and administrative
tasks. Not used during patient therapy.)
At full charge, the entire system can last at a minimum of 60 minutes and it is
recommended that a therapy session does not exceed 60 minutes. Please sufficiently
charge all components between use for a minimum of 60 minutes.
In the event of electromagnetic disturbances, the performance of the REAL Immersive
System may be affected.
The REAL Immersive System is a Type BF Applied Part.
Frequently used features and functions:
Headset
• Plug headset power cord into wall outlet and headset to charge device. •
Press power button to power on headset or restart headset. The power
button is on top of the headset.
Headset Controller
• Buttons on the controller are used to control power, connect to headset,
access settings, or control volume.
Large Sensor and Small Sensors
• Components are removed or placed back into the sensor charger (charging
station) to activate or charge device.
• Components are placed into the sensor bands.
Tablet
• Plug tablet power cord into wall outlet and tablet to charge device.
• Press power button to power on tablet or restart tablet. The power button is
on the edge of the device.
• User Interface:
- Selecting the application
- Logging in
- Adding or selecting patient
- Initializing and syncing to sensors
- Selecting, starting, modifying, or ending therapy session
- Viewing data
- Logging out
Sensor Charger
• Plug sensor charger power cord into wall outlet and sensor charger to power
on device to charge sensors.
Sensor Bands
• Place or remove sensor bands on or from patient.
There is no preventive inspection, calibration, and maintenance necessary for the
REAL Immersive System besides the initial set up procedure. During the three-year
product lifespan of the REAL Immersive System, the device will continue to perform
safely without any routine maintenance. No parts within the REAL Immersive System
will require inspection nor maintenance by a service personnel to ensure basic safety
during the three-year product lifespan. Circuit diagrams and calibration instructions
are not provided because service or parts repair is not necessary.
At the end of the three-year product lifespan, the user should dispose of the device
through an environmentally safe electronic waste recycle system. Contact the local
REAL representative if the following event occurs:
• The system no longer stays powered on and connected through the entire
recommended duration of a therapy session.
Supply mains are electrically isolated in medical equipment to maintain basic safety.