User's Manual
Table Of Contents
- All-In-One Headset with Software Application
- Headset Controller
- Large Sensor
- Small Sensors
- Sensor Charger (charging station)
- REAL Sensor Bands
- Headset
- Plug the headset power cord into wall outlet and the headset to charge device.
- Press power button to power on or off headset. The power button is on top of the headset.
- Headset Controller
- • Buttons on the controller are used to access settings.
- Sensor Charger
- Plug sensor charger power cord into wall outlet and sensor charger to power on device to charge sensors.
- Large Sensor and Small Sensors
- • Activate or charge sensor devices by removing or placing back into the sensor charging station.
- Place sensor devices into the sensor bands.
- Sensor Bands
- See Section 3 in Operating Procedures on instructions to put on sensor bands.
- User Portals
- Access the User Portal through the Headset to perform the following:
- o Logging in
- o Selecting the activity
- o Initializing and syncing to sensors
- o Starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- o Selecting the application
- o Logging in
- o Adding or selecting patient
- o Initializing and syncing to sensors
- o Selecting, starting, modifying, or ending therapy session
- o Viewing data
- o Logging out
- SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
- SECTION 3: START UP
- USER:
- 1. Using a personal device, log into the user portal using your username and password.
- 2. Select the activity assigned by your therapist within the user portal
- Section 4: ACTIVITY NAVIGATION
- Section 5: SYSTEM REMOVAL
Page 9 of 29
9. Once connected, the headset will display your home Wi-Fi at the top of the WLAN list and the
status will read ‘Connected’.
10. To exit, power off the headset before starting a session.
11. Ensure patient’s personal device such as computer, tablet or smartphone is connected to
desired Wi-Fi
12. Reset password to log into patient portal using the login information provided in the welcome
email
HCP:
1. Ensure your personal device is connected to the internet to access the portal and assign
activities to patients
2. Reset password to log into HCP portal using the log in information provided in the welcome
email
Continue to Section 3 when the components are sufficiently charged, and the system
has secure internet connectivity.
SECTION 3: START UP
USER:
1. Using a personal device, log into the user portal using your username and password.
2. Select the activity assigned by your therapist within the user portal
3. Remove sensor bands from the Real Sensor Bands box.
4. Remove all sensors from sensor charger.
5. Place the small sensors onto bands by sliding them into elasticized loops. For the hand sensor
bands, tighten elasticized loop using the buckle. Place large sensor into pocket of the torso
band.