User's Manual

PePLink Surf User’s Manual v2.6

Bit Rate: To fix the 802.11 transmit bit rate. Available options depend on

the Radio Mode chosen. If “auto” is chosen, the device will choose the best

bit rate dynamically and automatically.

Authentication: Available options are Open, Static WEP Key, 802.1x with

dynamic WEP key, WPA/WPA2-Enterprise and WPA/WPA2-Personal. The

selection should be according to the setting of the access point you are

associating to. Data transferred are encrypted under all modes except the

Open mode. When Static WEP Key or WPA/WPA2-Personal is chosen, you

should enter an encryption key in the Encryption Key field. For 802.1x and

WPA/WPA2-Enterprise options, please refer to chapter 4.4 .

Preferred AP: The MAC address of a preferred access point can be entered

here. When the preferred access point is found and its signal strength is

higher than the “Min Signal Strength”, it will connect to this preferred access

point, no matter the other access points are found even they have higher

signal strength or the same SSID.

WAI redirection: If the device is not connected to an access point, and the

user is accessing an Internet web site, the settings control whether to

redirect the web access to the web admin interface page or not. If this is

disabled and the device is not connected, the browser will then show web

access error. The user can still access the web admin interface by

accessing to the device’s LAN IP address. By default, it’s

http://192.168.20.1 .

Restore factory settings: To restore the device to factory default settings.

After clicked, the settings will be restored to factory defaults and the device

will be restarted.

Reboot: To restart the device.