User's Manual

PePLink Surf User’s Manual v2.6

4.4.2 Access Point

Access point set up procedure is different from one brand to the others.

Here are some necessary configuration parameters to be configured in the

access point:

- Enable WPA2 with 802.1x authentication

- Enter the radius server IP address, port number and the secret (for the

provided radius server config mentioned in 4.4.3 , the secret is

“testing123”)

4.4.3 Radius Server

The commercial radius server, Radiator, is used in the set up. It is a product

of Open System Consultants Pty Ltd.

Radiator version 3.9 is known to be interoperable. Any version above 3.9

should work too. Just follow the server’s installation guide to install it on a

server.

After installed, you should put the root cert file and server cert file to a

directory, update radiator’s configuration file and the users files.

A demo CA cert file (cacert.pem), a server cert file (server_cert.pem) and

a server key file (/etc/radiator/server_key.pem) are pre-generated and

attached. You can generate them by yourself by following the instructions

in the Appendix. Put the files to the directory /etc/radiator.

A sample Radiator configuration file is as follows. Save it as radius.cfg

and put it under /etc/radiator.