User Manual

PePLink PolePoint 200BG / 400BG User Manual

9 Appendix C – Professional Installation

Outdoor PolePoint 200/400BG requires professional installation. It is not to

be installed by the general public. You must be a Professional Installer. You

must follow Part 15 of the FCC rules, and specifically Part 15.203 pertaining

to antenna requirements of an intentional radiator.

If you are not a professional installer, STOP. Do not proceed any further with

the installation.

Note: Installing the Outdoor PolePoint 200/400BG requires setting the

antenna power, which required professional training. The installer must be

trained to perform this configuration.

You must be a Professional Installer to connect an antenna to the Outdoor

PolePoint 200/400BG, as specified in the Federal Communications

Commission’s part 15.203 for Radio Frequency Devices. The Outdoor

PolePoint 200/400BG uses a single low-loss Female N-type antenna

connector. You will need a Male N-type antenna to attach your antenna.

You will need a specialized RJ45 crimping device and RJ-45 connectors to

prepare and connect LAN cable to backbone network for Data and POE

power. Run the un-terminated RJ-45 cable through the Moisture proof Gland,

terminate a RJ-45 connector, and connect to board. Hand tighten down on

the gland nut until a good seal is provided around the Ethernet cable.

After the Ethernet is connected, close and seal the enclosure lid with the

mounting screws provided. Please tighten with a screwdriver to make a

positive seal.