User Manual

PePLink PolePoint 200BG / 400BG User Manual

4.1 Procedures

• Attach the antenna to the PePLink PolePoint unit.

• Connect its LAN port with the backbone network using either a

straight-through or cross-over cable.

• Plug the power adapter to a power socket and also the power input jack

on the unit.

• Wait until the status LED turns green

• Connect a PC to the backbone network, configure its IP address to be any

IP address between 192.168.0.4 to 192.168.0.254 with subnet mask of

255.255.255.0

• Visit the URL https://192.168.0.3/ (note that it is “HTTPS” based)

using Microsoft Internet Explorer 5 or above, or Mozilla Firefox 1.0 or

above. Accept all prompted questions

• You will be prompted for admin login ID and password. By default, they

are “admin” and “public”.

• You will see a page like this:

• You may now start to configure the PePLink PolePoint

Figure 2

Tips: If you are unable to access the pa

e, please refer to the

Appendix A - FAQ for how to restore the settin

s to factory

defaults.