User Manual

PePLink PolePoint 200BG / 400BG User Manual

To modify a virtual AP’s setting, click the link “Edit” on the right of a WLAN

SSID. Then you should see:

Enable: select Yes to enable the virtual AP, select No to disable the virtual

AP. The default is Yes.

WLAN SSID: the virtual APs’ SSID. It is the SSID to be scanned by Wi-Fi

clients. This value is case insensitive. The substring “####” in the SSID

will be replaced by the last four digits of the BSSID / MAC address. By

default, the value is “PePLink_####”.

Default VLAN ID: the VLAN ID to be tagged on all outgoing packets (leave

from the LAN port) generated from the virtual AP. If per-user VLAN ID is

specified in radius server’s authentication reply when 802.1x is enabled, the

Default VLAN ID will be overridden. Possible value is from 0 to 4096. The

default value is 0.

Broadcast SSID: to choose whether the virtual AP’s ESSID to be able to be

scanned by Wi-Fi clients or not. Note that BSSID (virtual AP’s MAC address)

Figure 6