User Manual
Table Of Contents
- 1 Introduction
- 2 Certificates and approvals
- 3 Product Description
- 3.1 RFID Frequency Bands
- 3.2 UHF general
- 3.3 Countries of Use
- 3.3.1 European Union
- 3.3.2 Argentina
- 3.3.3 Australia
- 3.3.4 Brazil
- 3.3.5 Canada
- 3.3.6 China
- 3.3.7 Hong Kong
- 3.3.8 India
- 3.3.9 Japan
- 3.3.10 Colombia
- 3.3.11 Malaysia
- 3.3.12 Morocco
- 3.3.13 Mexico
- 3.3.14 New Zealand
- 3.3.15 Russia
- 3.3.16 Singapore
- 3.3.17 South Korea
- 3.3.18 Thailand
- 3.3.19 United States of America
- 3.3.20 Vietnam
- 3.4 General Functions and Features
- 3.5 Indicators and Operating Elements
- 3.6 Connection
- 3.7 Scope of Delivery
- 3.8 Accessories
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Service and Maintenance
- 8 Troubleshooting
- 9 Appendix
IUH-F192-V1-*
Commissioning
2022-11
31
5.2 Initial Commissioning
All IUH-F192-V1-* read/write heads operate within their maximum frequency range from
865 MHz to 868 MHz, or from 902 MHz to 928 MHz, with the appropriate settings for the rele-
vant country. This enables the following parameters to be set according to the applicable regu-
lations for the relevant country:
• The maximum occupied bandwidth
• The channel bandwidth
• The channel plan used
• The frequency access method
• The maximum power setting
<WordAddr>: Word start address in the read/write tag, 4 hex
ASCII
characters,
range from "0000h" to "FFFF", depending on tag type
<WordNum>: Number of words to be read or written, 2 hex
ASCII
characters.
Range from "01" through "20" depending on the tag type, word
lengths are 4 bytes
Note
Transmission License
A country-specific transmission license is required to operate the read/write head. In the
European Union and Turkey, the manufacturer's EU declaration of conformity constitutes an
adequate license. A currently valid transmission license may not exist for all countries of use
listed in this chapter, as transmission licenses are temporary in some countries. All currently
valid transmission licenses can be found in the data sheet for the respective read/write head at
www.pepperl-fuchs.com
Warning!
Malfunctions with pacemakers
This device does not exceed the permissible limits for electromagnetic fields. Maintain a mini-
mum distance of 30 cm between the device and your pacemaker.
Inadequate distance from the read/write head can result in inhibitions, reprogramming, or incor-
rect stimulation pulses.
Note
Country Identifier
The IUH-F192-V1-FR* read/write head has no valid country identifier by default. This status is
indicated by the flashing green LED. In this state, the read/write head will accept only the
command for setting the relevant country identifier. Once you have parameterized a valid
country identifier, you can begin using the read/write head.
The IUH-F192-V1-FR2-02 is supplied ex-works with the country identifier "02" for the USA,
Canada, and Mexico. Due to legal regulations, you cannot change this country identifier in the
IUH-F192-V1-FR2-02.
Note
The country identifier set is saved in the read/write head as non-volatile. The country identifier
setting is not affected by a reset to the factory settings. It can be overwritten with another valid
country identifier at any time.