User Manual

IUH-F192-V1-*
Operation
2022-11
37
6.3 Command Overview
The commands in the list are described in detail on the following pages.
The following uses the command syntax for the IUH-F190-V1-* read/write heads with IDENT-
Control serial control interface. The channel number <ChanNo> is always included in the com-
mands. The command syntax is identical to the syntax of the IUT-F190-R4-V1-* read/write
heads with integrated RS-485 interface, except for the channel number. For the IUT-F190-R4-
V1-* read/write heads, the channel number <ChanNo> is not included in single-drop mode. In
multi-drop mode, the channel number <ChanNo> is replaced by the device address <Devi-
ceNo>. .
Read/Write Commands
Filter Commands
Configuration Commands
Abbrevia-
tion Command description
SF See "Single Read Read-Only Code SF" on page 38
EF See "Enhanced Read Read-Only Code EF" on page 38
SS See "Single Read Special Read-Only Code SS" on page 38
ES See "Enhanced Read Special Read-Only Code ES" on page 39
SP See "Single Write Special Read-Only Code SP" on page 39
SR, #SR See "Single Read Words SR" on page 40
ER, #ER See "Enhanced Read Words ER" on page 40
SW, #SW See "Single Write Words SW" on page 41
EW, #EW See "Enhanced Write Words EW" on page 41
KI See "Kill UHF Tag KI" on page 42
Abbrevia-
tion Command description
FI See "Set Filter Mask FI" on page 42
MF See "Activate/Deactivate Filter MF" on page 44
Abbrevia-
tion Command description
RP See "Read Parameters" on page 48
WP See "Write Parameters" on page 48