User Manual
Table Of Contents
- 1 Introduction
- 2 Certificates and approvals
- 3 Product Description
- 3.1 RFID Frequency Bands
- 3.2 UHF general
- 3.3 Countries of Use
- 3.3.1 European Union
- 3.3.2 Argentina
- 3.3.3 Australia
- 3.3.4 Brazil
- 3.3.5 Canada
- 3.3.6 China
- 3.3.7 Hong Kong
- 3.3.8 India
- 3.3.9 Japan
- 3.3.10 Colombia
- 3.3.11 Malaysia
- 3.3.12 Morocco
- 3.3.13 Mexico
- 3.3.14 New Zealand
- 3.3.15 Russia
- 3.3.16 Singapore
- 3.3.17 South Korea
- 3.3.18 Thailand
- 3.3.19 United States of America
- 3.3.20 Vietnam
- 3.4 General Functions and Features
- 3.5 Indicators and Operating Elements
- 3.6 Connection
- 3.7 Scope of Delivery
- 3.8 Accessories
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Service and Maintenance
- 8 Troubleshooting
- 9 Appendix
IUH-F192-V1-*
Certificates and approvals
2022-11
9
2.3 IC-Information
IC Exposure Information
To comply with IC RF exposure compliance requirements, the antennas used for this transmit-
ter must be installed to provide a separation distance of at least 35 cm from all persons and
must not be co-located or operated in conjunction with any other antenna or transmitter.
2.4 UL Information
Technical Data and Environmental Conditions
This device is for indoor use only.
This device may be operated in altitudes up to 2000 m.
The ambient temperature range is from -20 °C to +70 °C for operation with non-transmission
periods, or -20 °C to +60 °C for continuous transmission mode. The pollution degree is 2.
The maximum relative humidity is 80 % for temperatures up to 31 °C, decreasing linearly to 50
% relative humidity at 40 °C.
Nominal power supply voltage is 24 V
DC
, voltage range is 20 ... 30 V
DC
. Supply must be PELV
(Protective Extra Low Voltage). The overvoltage category II is applied.
This is the case if Pepperl+Fuchs IDENTControl control interface is used.
Protection class IP67 is not included in the UL approval. The protection class is tested by Pep-
perl+Fuchs AG.
The external circuits intended to be connected to this unit must be galvanically isolated from
the mains supply or hazardous live voltage by reinforced or double insulation and fall within the
limits specified in clauses 6.3 and 9.4 of UL 61010-1.
2.5 Additional country-specific approvals
For all current approvals see the data sheet of your read / write head under www.pepperl-
fuchs.com.
This device complies with Industry Canada licence-exempt RSS standard(s) and with part 15
of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.