Product Card
Table Of Contents
- 16 Port Forwarding
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 20 Routing Protocols
- 21 Remote User Access
- 22 Miscellaneous Settings
- 23 AP
- 24 AP Controller Status
- 25 Toolbox
- 26 System Settings
- 27 Tools
- 28 Status
- 29 WAN Quality
- 30 Usage Reports
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
117
Copyright @ 2021 Pepwave
15.2.6 Algorithm: Least Used
The traffic matching this rule will be routed through the healthy WAN connection that is selected
in Connection and has the most available download bandwidth. The available download
bandwidth of a WAN connection is calculated from the total download bandwidth specified on
the WAN settings page and the current download usage. The available bandwidth and WAN
selection is determined every time an IP session is made.
15.2.7 Algorithm : Lowest Latency
The traffic matching this rule will be routed through the healthy WAN connection that is selected
in Connection and has the lowest latency. Latency checking packets are issued periodically to
a nearby router of each WAN connection to determine its latency value. The latency of a WAN
is the packet round trip time of the WAN connection. Additional network usage may be incurred
as a result.
Tip
The roundtrip time of a 6M down/640k u
plink can be higher than that of a 2M down/2M up link because
the overall round trip time is lengthened by its slower upload bandwidth, despite its higher downlink speed.
Therefore, this algorithm is good for two scenarios:
● All WAN connections are symmetric; or
●
A latency sensitive application must be routed through the lowest latency WAN, regardless of the
WAN’s available bandwidth.
15.2.8 Expert Mode
Expert Mode is available on some Pepwave routers for use by advanced users. To enable the