User's Manual

https://www.peplink.com 44 Copyright @ 2020 Pepwave
PPPoE Settings
Routing Mode
NAT allows substituting the real address in a packet with a mapped address
that is routable on the destination network. By clicking the help icon in this field,
you can display the IP Forwarding option, if your network requires it.
IP Address /
Subnet Mask /
Default Gateway
This information is obtained from the ISP automatically.
PPPoE Username /
Password
Enter the required information in these fields in order to connect via PPPoE to
the ISP. The parameter values are determined by and can be obtained from
the ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Service Name
(Optional)
Service name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
IP Address
(Optional)
If your ISP provides a PPPoE IP address, enter it here.
Note: Leave this field blank unless it is provided by your ISP.
DNS Servers
Each ISP may provide a set of DNS servers for DNS lookups. This setting
specifies the DNS (Domain Name System) servers to be used when a DNS
lookup is routed through this connection. Selecting Obtain DNS server
address automatically results in the DNS servers being assigned by the WAN
DHCP server to be used for outbound DNS lookups over the connection. (The
DNS servers are obtained along with the WAN IP address assigned from the
DHCP server.) When Use the following DNS server address(es) is selected,
you may enter custom DNS server addresses for this WAN connection into the
DNS Server 1 and DNS Server 2 fields.