User's Manual

https://www.peplink.com 50 Copyright @ 2020 Pepwave

bands (frequencies) .

When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.

Data Roaming

This checkbox enables data roaming on this particular SIM card. When data roaming is enabled

this option allows you to select in which countries the SIM has a data connection. The option is

configured by using MMC (country) codes.Please check your service providers data roaming

policy before proceeding.

Authentication

Choose from PAP Only or CHAP Only to use those authentication methods

exclusively. Select Auto to automatically choose an authentication method.

Operator Settings

This setting alloes allows you to configure the APN settings of your connection. If Auto

is selected, the mobile operator should be detected automatically. The connected

device will be configured and connection will be made automatically. If there is any

difficulty in making connection, you may select Custom to enter your carriers APN,

obtained from your carrier. The default and recommended setting is Auto.

APN / Login /

Password /

SIM PIN

When Auto is selected, the information in these fields will be filled automatically. Select

Custom to customize these parameters. The parameter values are determined by and

can be obtained from the ISP.

Bandwidth

Allowance

Monitor

Check the box Enable to enable bandwidth usage monitoring on this WAN connection

for each billing cycle. When this option is not enabled, bandwidth usage of each month

is still being tracked but no action will be taken.

Action

If email notification is enabled, you will be notified by email when usage hits 75% and

95% of the monthly allowance. If Disconnect when usage hits 100% of monthly

allowance is checked, this WAN connection will be disconnected automatically when

the usage hits the monthly allowance. It will not resume connection unless this option

has been turned off or the usage has been reset when a new billing cycle starts.

Start Day

This option allows you to define which day of the month each billing cycle begins.

Monthly

Allowance

This field is for defining the maximum bandwidth usage allowed for the WAN

connection each month.

Signal Threshold Settings

If signal threshold is defined, this connection will be treated as down when a weaker than

threshold signal is determined.

The following values are used by the threshold scale: