User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
Network
Connection
This option is for specifying the network connection to be used for authentication.
Users can choose from LAN, WAN, and VPN connections.
CLI SSH
The CLI (command line interface) can be accessed via SSH. This field enables
CLI support. For additional information regarding CLI, please refer to
Section
30.5.
CLI SSH Port
This field determines the port on which clients can access CLI SSH.
CLI SSH Access
This menu allows you to choose between granting access to LAN and WAN
clients, or to LAN clients only.
Security
This option is for specifying the protocol(s) through which the web admin interface
can be accessed:
● HTTP
● HTTPS
● HTTP/HTTPS
Web Admin Port
This field is for specifying the port number on which the web admin interface can
be accessed.
Web Admin
Access
This option is for specifying the network interfaces through which the web admin
interface can be accessed:
● LAN only
● LAN/WAN
If LAN/WAN is chosen, the WAN Connection Access Settings
form will be
displayed.
LAN Connection Access Settings
Allowed LAN
Networks
This field allows you to permit only specific networks or VLANs to access the Web UI.