User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
Email Notification Settings
Email
Notification
This setting specifies whether or not to enable email notification. If Enable
is
checked, the Pepwave router will send email messages to system administrators
when the WAN status changes or when new firmware is available. If Enable
is not
checked, email notifi
cation is disabled and the Pepwave router will not send email
messages.
SMTP Server
This setting specifies the SMTP server to be used for sending email. If the server
requires authentication, check Require authentication.
SSL Encryption
Check the box to enable SMTPS. When the box is checked, SMTP Port
will be
changed to 465 automatically.
SMTP Port
This field is for specifying the SMTP port number. By default, this is set to 25
; when
SSL Encryption is checked, the default port number will be set to 465
. You may
customize the port number by editing this field. Click Default
to restore the number
to its default setting.
SMTP User
Name /
Password
This setting specifies the SMTP username and password while sending email.
These options are shown only if Require authentication is checked in the
SMTP
Server setting.
Confirm SMTP
Password
This field allows you to verify and confirm the new administrator password.
Sender’s Email
Address
This setting specifies the email address the Pepwave router will use to send reports.
Recipient’s
Email Address
This setting specifies the email address(es) to which the Pepwave router will send
email notifications. For multiple recipients, separate each email addresses using the