User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
● PING - ICMP PING packets will be issued to test connectivity with
configurable target IP addresses or host names.
● DNS Lookup -
DNS lookups will be issued to test the connectivity with
configurable target DNS server IP addresses.
● HTTP -
HTTP connections will be issued to test the connectivity with
configurable URLs and strings to match.
Default: DNS Lookup
PING Hosts
These fields are for specifying the target IP addresses or host names where ICMP
Ping packets will be sent to for health check.
If the box Use first two DNS servers as PING Hosts is checked, the first two DNS
servers will be the ping targets for checking t
he connection healthiness. If the box is
not checked, the field Host 1 must be filled and the field Host 2 is optional.
The connection is considered to be up if ping responses are received from any one
of the ping hosts.
Timeout
If a health check test can
not be completed within the specified amount of time, the
test will be treated as failed.
Health Check
Interval
This is the time interval between each health check test.
Health Check
Retries
This is the number of consecutive check failures before treating a connection as
down.
Recovery
Retries
This is the number of responses required after a health check failure before treating
a connection as up again.
Bandwidth Allowance Monitor Settings
Bandwidth
Check the box Enable to enable bandwidth usage monitoring on this WAN