User's Manual
Table Of Contents
- 1 Introduction and Scope
- Glossary
- 2 Product Features
- 3 Pepwave MAX Mobile Router Overview
- 4 Advanced Feature Summary
- 5 Installation
- 6 Mounting the Unit
- 7 Connecting to the Web Admin Interface
- 8 Configuring the LAN Interface(s)
- 9 Configuring the WAN Interface(s)
- 10 Advanced Wi-Fi Settings
- 11 ContentHub Configuration
- 12 MediaFast Configuration
- 13 Bandwidth Bonding SpeedFusionTM / PepVPN
- 14 IPsec VPN
- 15 Outbound Policy Management
- 16 Inbound Access
- 17 NAT Mappings
- 18 QoS
- 19 Firewall
- 22 Remote User Access
- 23 Miscellaneous Settings
- 24 AP - access point
- 26 AP Controller Status
- 27 Toolbox
- 28 System Settings
- 29 Tools
- 30 Status
- Appendix A: Restoration of Factory Defaults
- Appendix B: Declaration
https://www.peplink.com
Copyright @ 2021 Pepwave
Cellular Settings
SIM Card
Indicate which SIM card this cellular WAN will use. Only applies to cellular WAN with
redundant SIM cards.
Preferred SIM
Card
If both cards were enabled on the above field, then you can designate the priority of
the SIM card slots here.
LTE/3G
This drop-down menu allows restricting cellular to particular band. Click the
button
to enable the selection of specific bands.
Optimal
Network
Discovery
Cellular WAsN by default will only handover from 3G to LTE network when there is no active
data tra
ffic, enable this option will make it run the handover procedures after fallback to 3G for
a defined effective period, even this may interrupt the connectivity for a short while.
Band Selection
When set to
Auto, band selection allows for automatically connecting to available, supported