User's Manual

https://www.peplink.com
46
Copyright @ 2019 Pepwave
Cellular Settings
SIM Card
Indicate which SIM card this cellular WAN will use. Only applies to cellular WAN with
redundant SIM cards.
Preferred SIM
Card
If both cards were enabled on the above field, then you can designate the priority of
the SIM card slots here.
LTE/3G
This drop-down menu allows restricting cellular to particular band. Click the
button to enable the selection of specific bands.
Optimal
Network
Discovery
Cellular WAsN by default will only handover from 3G to LTE network when there is no active
data traffic, enable this option will make it run the handover procedures after fallback to 3G for
a defined effective period, even this may interrupt the connectivity for a short while.
Band Selection
When set to Auto, band selection allows for automatically connecting to available, supported
bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will connect to.
Data Roaming
This checkbox enables data roaming on this particular SIM card. When data roaming is
enabled this option allows you to select in which countries the SIM has a data connection. The
option is configured by using MMC (country) codes.Please check your service provider’s data
roaming policy before proceeding.
Authentication
Choose from PAP Only or CHAP Only to use those authentication methods
exclusively. Select Auto to automatically choose an authentication method.
Operator Settings
This setting alloes allows you to configure the APN settings of your connection. If
Auto is selected, the mobile operator should be detected automatically. The
connected device will be configured and connection will be made automatically. If
there is any difficulty in making connection, you may select Custom to enter your
carrier’s APN, Login, Password, and Dial Number settings manually. The correct
values can be obtained from your carrier. The default and recommended setting is
Auto.
APN / Login /
Password /
SIM PIN
When Auto is selected, the information in these fields will be filled automatically.
Select Custom to customize these parameters. The parameter values are
determined by and can be obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN
connection for each billing cycle. When this option is not enabled, bandwidth usage
of each month is still being tracked but no action will be taken.