Users Manual

https://www.peplink.com 155 Copyright @ 2019 Peplink
*Upgrading the firmware will cause the router to reboot.
Web admin interface : install updates manually
In some cases, a special build may be provided via a ticket or it may be found in the forum. Upgrading to
the special build can be done using this method, or using IC2 if you are using that to manage your
firmware upgrades. A manual upgrade using the GA firmware posted on the site may also be
recommended or required for a couple of reasons.
All of the Peplink/Pepwave GA firmware can be found here Navigate to the relevant product line (ie.
Balance, Max, FusionHub, SOHO, etc). Some product lines may have a dropdown that lists all of the
products in that product line. Here is a screenshot from the Balance line.
If the device has more than one firmware version the current hardware revision will be required to know
what firmware to download.
Navigate to System > Firmware and click the Choose File button under the Manual Firmware Upgrade
section. Navigate to the location that the firmware was downloaded to select the “.img” file and click the
Open button.
Click on the Manual Upgrade button to start the upgrade process.
A prompt will be displayed advising to download the Current Active Configuration. Please click on the
underlined download text. After downloading the current config click the Ok button to start the upgrade
process. The firmware will now be applied to the router*. The amount of time it takes for the firmware to
upgrade will depend on the router that’s being upgraded.