Users Manual

configured LAN IP address.

● At a subsequent point when the master Pepwave router recovers, it will once again

become active.

You can configure high availability at Advanced>Misc. Settings>High Availability.

Interface for Master Router

Interface for Slave Router

High Availability

Enable

Checking this box specifies that the Pepwave router is part of a high availability

configuration.

Group Number

This number identifies a pair of Pepwave routers operating in a high availability

configuration. The two Pepwave routers in the pair must have the same Group

Number value.

Preferred Role

This setting specifies whether the Pepwave router operates in master or slave

mode. Click the corresponding radio button to set the role of the unit. One of the

units in the pair must be configured as the master, and the other unit must be

configured as the slave.

Resume Master

Role Upon

Recovery

This option is displayed when Master mode is selected in Preferred Role. If this

option is enabled, once the device has recovered from an outage, it will take over

and resume its Master role from the slave unit.

Configuration

Sync.

This option is displayed when Slave mode is selected in Preferred Role. If this

option is enabled and the Master Serial Number entered matches with the actual

master unit's, the master unit will automatically transfer the configuration to this unit.

Please make sure the LAN IP Address and the Subnet Mask fields are set

correctly in the LAN settings page. You can refer to the Event Log for the

configuration synchronization status.

Master Serial

Number

If Configuration Sync. is checked, the serial number of the master unit is required

here for the feature to work properly.

Virtual IP

The HA pair must share the same Virtual IP. The Virtual IP and the LAN

https://www.peplink.com

164