User's Manual

Card

of the SIM card slots here.

Remote SIM

Settings

If “Use Remote SIM Only” is selected in the SIM card section, the Remote SIM

Settings will be shown.

You may need to enable the remote SIM Host settings in the Remote SIM

management, see the section 22.10 or Appendix B for more details on FusionSIM.

After that, click on “Scan nearby remote SIM server” to show the serial number(s)

of the connected SIM Injector(s).

If you want to select a specific SIM, in the Cellular Settings, type “:” and then the

number of the SIM slot, eg.1111-2222-3333:7.

LTE/3G

This drop-down menu allows restricting cellular to particular band. Click the

button to enable the selection of specific bands.

Optimal

Network

Discovery

Cellular WANs by default will only handover from 3G to LTE network when there is

no active data traffic, enable this option will make it run the handover procedures

after fallback to 3G for a defined effective period, even this may interrupt the

connectivity for a short while.

Band Selection

When set to Auto, band selection allows for automatically connecting to available,

supported bands (frequencies) .

When set to Manual, you can manually select the bands (frequencies) the SIM will

connect to.

Data Roaming

This checkbox enables data roaming on this particular SIM card. When data roaming

is enabled this option allows you to select in which countries the SIM has a data

connection. The option is configured by using MMC (country) codes.Please check

your service provider’s data roaming policy before proceeding.

Authentication

Choose from PAP Only or CHAP Only to use those authentication methods

exclusively. Select Auto to automatically choose an authentication method.

Operator

Settings

This setting allows you to configure the APN settings of your connection. If Auto is

selected, the mobile operator should be detected automatically. The connected

device will be configured and connection will be made automatically. If there is any

difficulty in making connection, you may select Custom to enter your carrier’s APN,

obtained from your carrier. The default and recommended setting is Auto.