Users Manual

https://www.peplink.com 126 Copyright @ 2021 Peplink
Inter-VLAN
routing
Check this box to enable routing between virtual LANs.
Layer 2 PepVPN Bridging
PepVPN
Profiles to
Bridge
The remote network of the selected PepVPN profiles will be bridged with this local LAN,
creating a Layer 2 PepVPN, they will be connected and operate like a single LAN, and any
broadcast or multicast packets will be sent over the VPN.
Remote
Network
Isolation
Enable this option if you want to block network traffic between the remote networks, this will
not affect the connectivity between them and this local LAN.
Spanning Tree
Protocol
Click the box will enable STP for this layer 2 profile bridge.
Override IP
Address when
bridge
connected
Select "Do not override" if the LAN IP address and local DHCP server should remain
unchanged after the Layer 2 PepVPN is up.
If you choose to override IP address when the VPN is connected, the device will not act as a
router, and most Layer 3 routing functions will cease to work.
DHCP Option
82
Click on the question Mark if you want to enable DHCP Option 82.
This allows the device to inject Option 82 with Router Name information before forwarding the
DHCP Request packet to a PepVPN peer, such that the DHCP Server can identify where the
request originates from.