Users Manual

https://www.peplink.com 154 Copyright @ 2021 Peplink
By
Destination:
The same WAN connection will be used for traffic matching the rule, originating from the
same machine, and going to the same destination. This option can better distribute loads
to WAN connections when there are only a few client machines.
The default mode is By Source. When there are multiple client requests, they can be distributed
(persistently) to WAN connections with a weight. If you choose Auto in Load Distribution, the weights will
be automatically adjusted according to each WAN’s Downstream Bandwidth which is specified in the
WAN settings page). If you choose Custom, you can customize the weight of each WAN manually by using
the sliders.
Algorithm:Enforced 
This setting specifies the WAN connection usage to be applied on the specified IP protocol and port. This
setting is applicable only when Algorithm is set to Enforced.
Matching traffic will be routed through the specified WAN connection, regardless of the health check status
of the WAN connection. Outbound traffic can also be enforced to go through a specified SpeedFusion
TM
connection.
Algorithm:Priority 
This setting specifies the priority of the WAN connections used to route the specified network service. The
highest priority WAN connection available will always be used for routing the specified type of traffic. A
lower priority WAN connection will be used only when all higher priority connections have become
unavailable.