User's Manual

https://www.peplink.com 30 Copyright @ 2019 Pepwave
LAN Physical Settings
Speed
This is the port speed of the LAN interface. It should be set to the same speed as
the connected device to avoid port negotiation problems. When a static speed is
set, you may choose whether to advertise its speed to the peer device. Auto is
selected by default. You can choose not to advertise the port speed if the port
has difficulty negotiating with the peer device.
Static Route Settings
Static Route
This table is for defining static routing rules for the LAN segment. A static route
consists of the network address, subnet mask, and gateway address. The
address and subnet mask values are in w.x.y.z format.
The local LAN subnet and subnets behind the LAN will be advertised to the VPN.
Remote routes sent over the VPN will also be accepted. Any VPN member will be
able to route to the local subnets. Press to create a new route. Press
to remove a route.