User's Manual

https://www.peplink.com 82 Copyright @ 2019 Pepwave

http://youtu.be/TLQgdpPSY88

12.2 The Pepwave Router Behind a NAT Router

Pepwave routers support establishing SpeedFusion

over WAN connections which are behind

a NAT (network address translation) router.

To enable a WAN connection behind a NAT router to accept VPN connections, you can

configure the NAT router in front of the WAN connection to inbound port-forward TCP port

32015 to the Pepwave router.

If one or more WAN connections on Unit A can accept VPN connections (by means of port

forwarding or not), while none of the WAN connections on the peer Unit B can do so, you should

enter all of Unit A’s public IP addresses or hostnames into Unit B’s Remote IP Addresses /

Host Names field. Leave the field in Unit A blank. With this setting, a SpeedFusion

connection

can be set up and all WAN connections on both sides will be utilized.

See the following diagram for an example of this setup in use: