User's Manual

http://www.peplink.com 91 Copyright @ 2019 Pepxim

By Destination: The same WAN connection will be used for traffic matching the rule, originating from the

same machine, and going to the same destination. This option can better distribute loads

to WAN connections when there are only a few client machines.

The default mode is By Source. When there are multiple client requests, they can be

distributed (persistently) to WAN connections with a weight. If you choose Auto in Load

Distribution, the weights will be automatically adjusted according to each WAN’s

Downstream Bandwidth which is specified in the WAN settings page). If you choose

Custom, you can customize the weight of each WAN manually by using the sliders.

14.2.3 Algorithm: Enforced

This setting specifies the WAN connection usage to be applied on the specified IP protocol and

port. This setting is applicable only when Algorithm is set to Enforced.

Matching traffic will be routed through the specified WAN connection, regardless of the health

check status of the WAN connection. Starting from Firmware 5.2, outbound traffic can be

enforced to go through a specified SpeedFusion

connection.

14.2.4 Algorithm: Priority

This setting specifies the priority of the WAN connections used to route the specified network

service. The highest priority WAN connection available will always be used for routing the

specified type of traffic. A lower priority WAN connection will be used only when all higher

priority connections have become unavailable.