Instructions / Assembly

DO THIS FIRST
(for existing sleeve)
Note that the air conditioner dimensions are:
24.25 inches wide, 14.5 inches, and 18.5 inches
deep (without front).
Install air conditioner according to these installation
instructions to achieve the best performance. Save
these installation instructions for future reference.
NOTE: Do not use any screws other than those
specified in these instructions.
Items in Kit
You may not need all parts in the kit. Discard unused parts.
Item Dimensions (if applicable) Quantity
Tapered Spacer Blocks 17″ Long 2
Centering/Support Blocks 4
1
/
2″ x 3
1
/
2″ x 1
1
/
2″ 4
Plastic Divider
1
/
8″ x 4
1
/
2″ x 14
1
/
2″ 2
Stuffer Seal 1″ x 1
1
/
2″ x 84″ 1
Seal 1″ x 1
1
/
2″ x 25″ 3
Seal 1″ x 1
1
/
2″ x 14″ 2
Seal 1″ x
3
/
8″ x 25″ 3
Seal 1″ x
3
/
8″ x 14″ 2
Seal 1″ x
3
/
4″ x 14″ 2
Trim Frame (side legs) 2
Trim Frame (top & bottom legs) 2
Ground Wire (green) 1
Toothed washer for grounding screw 2
Grounding Screw 1
Grille (plastic) 1
Grille (aluminium) 1
Nuts (plastic) 4
Screw Washer 4
Screw 4
INSTALLATION INSTRUCTIONS
Read these instructions completely
and carefully.
IMPORTANT- Save these instructions.
IMPORTANT- Observe all
governing codes and ordinances.
Note to Consumer- Keep these
instructions for future reference.
Note to Installer- Be sure to leave these
instructions with the Consumer.
Completion time- Approximately 1 hour.
Skill level- Installation of this appliance
requires basic mechanical skills.
We recommend that two people install
this product.
Proper installation is the responsibility
of the installer.
Product failure due to improper installation
is not covered under the Warranty.
You MUST use all supplied parts and use
proper installation procedures as described
in these instructions when installing this air
conditioner.
BEFORE YOU BEGIN
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
CAUTION
Do not change the plug on the power cord
of the air conditioner.
Aluminum house wiring may present special
problems- consult a qualified electrician.
When handling unit, be careful to avoid cuts from
sharp metal edges and aluminum fins on front and
rear coils.
8