DEHUMIDIFIER USER MANUAL FOR MODELS: 4PAD30 4PAD50 4PAD70 Before using your dehumidifier, please read this manual carefully and keep it for future reference, along with your receipt.
CONSUMER PRODUCT INFORMATION For your own records, please attach a copy of your sales receipt to this manual and complete the following: Model Number:______________________________________ Serial Number: ________________________________________ Purchase Date: _____________________________________ Store Purchased: ______________________________________ Installation Date: ____________________________________ Installation Co.
QUICK START TIPS IT IS HIGHLY SUGGESTED THAT THE MANUAL BE READ IN FULL BEFORE OPERATING THE UNIT. However, the notes below are especially important in helping you to properly set up and begin to use your dehumidifier. 1. The dehumidifier should be kept upright. If for any reason it has not been stored upright while in your possession, put the unit in an upright position for a minimum of 24 hours before running it. 2. When first using the dehumidifier, operate the unit on CONTINUOUS mode for 24 hours.
CONTENTS SAFETY PRECAUTIONS....................................................................1 ELECTRICAL INFORMATION...........................................................2 CONTROL PADS ON THE DEHUMIDIFIER.....................................3 IDENTIFICATION OF PARTS............................................................5 OPERATING THE UNIT......................................................................6 CARE AND MAINTENANCE.............................................................
SAFETY PRECAUTIONS READ SAFETY PRECAUTIONS BEFORE INSTALLATION To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by the following indications. THIS SYMBOL INDICATES THAT IGNORING INSTRUCTIONS MAY CAUSE DEATH OR SERIOUS INJURY.
CAUTIONS DO NOT use the unit in small spaces. Lack of ventilation can cause overheating and fire. DO NOT put in places where water may splash onto the unit. Water entering unit can degrade the insulation and cause electric shock or fire. Place the unit on a level, sturdy section of the floor. If unit falls over, it may spill water and damage belongings, or cause electric shock or fire. DO NOT cover the intake or exhaust openings with cloths or towels.
CONTROL PADS ON THE DEHUMIDIFIER NOTE: The control panel of the unit you purchased may be slightly different according to the models. Clean Filter Indicator Light 3 Comfort Dehumidifying Indicator Light High Fan Indicator Light 8 Filter Turbo Comfort Full 2 Cont.
ERROR AND PROTECTION CODES AS – HUMIDITY SENSOR ERROR Unplug the unit for at least 5 minutes and plug it back in. Make sure the filter is clean. If error repeats, call Perfect Aire Consumer Services at 844.472.2473. ES – TEMPERATURE SENSOR ERROR Unplug the unit for at least 5 minutes and plug it back in. Make sure the filter is clean. If error repeats, call Perfect Aire Consumer Services at 844.472.2473.
IDENTIFICATION OF PARTS FRONT 1. Control Panel 2. Air Filter (pull up to remove) 3. Air Outlet Grill 4. Air Intake Grill REAR 1 6 2 4 3 1. Drain Hose Outlet 1 3. Power Cord & Plug 4. Band (used only when storing unit) 5 5. Water Bucket 6. Handle (both sides) 4 2. Casters 22 FIG. 2 3 FIG. 3 CASTERS (#2 in diagram above) • The casters are located at four points on the bottom of the unit. • Casters can move freely.
OPERATING THE UNIT POSITIONING THE UNIT A dehumidifier operating in one room will have little or no effect in drying an adjacent enclosed area, such as a closet, or other room unless there is adequate circulation of air around the area. • Do not use outdoors. • This dehumidifier is intended for indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications.
REMOVING THE COLLECTED WATER: 2 OPTIONS OPTION 1: USE THE BUCKET OPTION 1: USE THE BUCKET A dehumidifier operating in one room will have little or no effect in FIG. 7 FIG. 8 drying an adjacent enclosed area, such as a closet, or other room unless there is adequate circulation in the area. • If the bucket is full when the unit is OFF, the unit will beep 8 times, the Full indicator light will flash and the display will show P2.
CARE AND MAINTENANCE CARE AND CLEANING OF THE DEHUMIDIFIER TURN THE DEHUMIDIFIER OFF AND REMOVE THE PLUG FROM THE WALL OUTLET BEFORE CLEANING. 1. CLEAN THE GRILLE AND CASE • Use a damp cloth with water and a mild detergent. Do not use bleach or abrasives. • Do not splash water directly onto the main unit. Doing so may cause electrical shock, cause the insulation to deteriorate, or cause the unit to rust. • The air intake and outlet grilles get soiled easily; use a vacuum attachment or brush to clean. 2.
TROUBLESHOOTING BEFORE CALLING FOR SERVICE, PLEASE REVIEW THE CHART BELOW ISSUE POSSIBLE CAUSES AUTO DEFROST DISPLAYS REPEATEDLY • Turn off unit and unplug 4-6 hours. • Plug unit back in. Run in Normal mode (no Turbo fan, not on Continuous operation) and set humidity level to no more than 5% lower humidity than what the display reads for the room humidity. • Allow time for the unit to run until it successfully reaches initial humidity setting.
BEFORE CALLING FOR SERVICE, PLEASE REVIEW THE CHART BELOW ISSUE POSSIBLE CAUSES DEHUMIDIFIER ALWAYS RUNNING • Be sure unit is not too large or too small for the area of the room. • Allow enough time for unit to remove moisture. • If set on CONTINUOUS mode, de-select button and set unit to an appropriate humidity setting. • If humidity in room is above the set humidity, then unit will be running. • Be sure all doors, windows and other openings are securely closed.
Distributed by: Perfect Aire, LLC 5151 Belt Line Rd. Suite 878 Dallas, TX 75254 844-4PA-AIRE | 844-472-2473 www.perfectaire.us PA/User_4PAD30_4PAD50_4PAD70/10102017 Specification and performance data is subject to change without notice.