Instructions / Assembly

Wall Sleeve Brands:

#1 Emerson • 15″ Deep

1. Remove existing rear grille as shown on page 11

of this manual and replace with provided louvered

panel. Install as shown here.

Note: You may need to drill holes in flange of existing

sleeve to match new rear grille.

2. Attach (1) 1″ x

8″ x 25″ long seal in the center at

the top of the sleeve. Remove the backing paper and

press into position.

3. Attach the (2) 1″ x

8″ x 14″ long seals to the left

and right sides of the sleeve.

4. Cut (2) 1″ x

8″ x 25″ long seals to 14″ long and

attach to the vertical sections of the rear grille

as shown.

5. Attach (2) 4½″ x 3½″ x1½″ centering/support

blocks, one on each side wall. Place in center of side

wall with the tapered end facing the opening.

6. Gently slide unit into sleeve.

7. Before sliding all the way back, remove 2nd screw

from front on left side of unit.

8. Remove the plastic washer from the screw.

9. Screw and attach the other end of the ground wire

to the unit as shown in picture. Make sure that the toothed

washer is against the cabinet.

10. Slide the unit completely to the rear to ensure a

good seal, making sure the ground wire does not

become tangled.

11. Seal & frame the unit as described on page 21.

12. If you have difficulty with mounting the grille to the

sleeve, follow the instructions for direct mounting on

page 20.

4 4

INSTALLATION INSTRUCTIONS (CONTINUED)