Instructions / Assembly

#8 Perfect Aire, White Westinghouse,

Frigidaire, Carrier 52F Series •

16″ & 17½″ Deep

1. Remove existing rear grille as shown on page 11

of this manual and replace with provided louvered

panel. Install as shown here.

Note: You may need to drill holes in flange of existing

sleeve to match new rear grille.

2. Attach (1) 1″ x

8″ x 25″ long seal in the center at the top

of the sleeve. Remove the backing and press into position.

3. Attach (2) 1″ x

8″ x 14″ long seals to the left and right

sides of the sleeve.

4. Attach (1) 1″ x ¾″ x 14″ long seal vertically 4.5” from the

left side of the sleeve. Attach the other 1″ x ¾″ x 14″ long

seal 4” from the right slide of the sleeve.

5. Center unit and gently slide unit into sleeve.

6. Before sliding all of the way back, remove 2nd screw from

front on left side of unit.

7. Remove the plastic washer from the screw.

8. Screw and attach the other end of the ground wire to the

unit as shown in picture. Make sure that the toothed washer

is against the cabinet.

9. Slide the unit completely to the rear to ensure a good

seal, making sure the ground wire does not become tangled.

10. Seal & frame the unit as described on page 21.

11. If you have difficulty with mounting the grille to the

sleeve, follow the instructions for direct mounting on

page 20.

INSTALLATION INSTRUCTIONS (CONTINUED)

Wall Sleeve Brands: