Instructions / Assembly
7
center handles
AIR CONDITIONER FEATURES (CONTINUED)
DISPLAY
Display
NOTE: If the unit breaks off unexpectedly
due to power being cut, it will restart with
the previous function setting automatically
when the power resumes.
Error Codes:
AS - Room temperature sensor error - Unplug the unit and
plug it back in. If error repeats, call Consumer Services.
NOTE: If an error code occurs in “Fan” only mode, unit will
display “LO” (loose connection) or “HI” (short circuit).
Perfect Aire Consumer Services: 844-472-2473
- Evaporator temperature sensor error - Unplug the unit
and plug it back in. If error repeats, call Consumer Services.
(“ ” is displayed as shown in left picture.)
HS - Electric heating sensor error - Unplug the unit and
plug it back in. If error repeats, call Consumer Services.
The display shows the set temperature in “°C” or “°F” and
the Auto-timer settings. While on “Fan” only mode, it shows
the room temperature.
Air Direction
(4-way)
AIR DIRECTIONAL LOUVERS
ADDITIONAL THINGS YOU SHOULD KNOW
Use the 4-way directional louvers to direct the air flow up
or down and left or right throughout the room as needed.
Pivot horizontal louvers until the desired up/down
direction is obtained.
Move the center handles from side to side until the
desired left/right direction is obtained.
There are a total of 4 possible air directional orientations
available with this system.
• The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. After unit is
turned off, leave unit off for a minimum of 3 minutes before attempting to turn back on. This prevents overheating of
the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
• The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to
the other, press and hold the Up and Down Temp/Timer buttons at the same time for 3 seconds.