Instruction Manual

HOW TO INSTALL

NOTE: Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of

(5/16 ). This is

Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel- be sure

to use the proper panel for each side. When installed the flange for securing the panel in place to

the window sill will be facing into the room.

necessary for proper condensed water utilization and drainage. If you are

not using the Side Panels for any reason, this pitch to the rear must be maintained.

Fig.1

A. Hold the Accordion Panel

in one hand and gently

pull back the center to free

the open end. See Fig.1.

Fig.2A

Fig.2B

B. Slide the side rail into the cabinet as shown

in Fig. 2A 2B. Slide the panel down.

Be sure to leave enough space to slip the top

and bottom of the frame into the rails on the

cabinet as shown in Fig. 3.

C. Once the panel has been installed on the side

of the cabinet, make sure it sits securely inside

the frame channel by making slight adjustments.

Slide the top and bottom ends of the frame into

the top and bottom rails of the cabinet. Fig.4.

D. Slide the panel all the way in and repeat on the

other side.

NOTE: If storm window blocks AC, see Fig. 11.

Fig.3

Fig.4