User's Manual

ManualsBrandsPerfect Toys International ManualsToys & GamesRemote Control Toy Transmitter

TRANSMITTER’S MANUAL

ITEM NO.: 30113

INSTALLATION OF THE TRANSMITTER

BATTERY’S SETUP

Please use eight “AA” alkaline batteries or rechargeable batteries.

First: In light of arrow’s direction, push the cover of battery case away,

and lift it to sever the transmitter.

Second: Insert eight batteries and pay attention to batteries’ anode and

cathode.

Third: push the cover of battery case to original place.

Note: If using rechargeable batteries, you should use the intelligent

charger(No.40108). Its charging range is 1H—1.5H.

INDICATOR LIGHT

If having full electric energy in the transmitter, the green, the red, and the

yellow light will all on.

If the green light goes out, it indicates the electric energy is not full, and

possibly have half one.

If the yellow light blinks, it indicates the electric energy is not full, and

you should replace or recharge the batteries.

If the red light brights, you should replace or recharge the batteries.

Summary of content (4 pages)

PAGE 1
TRANSMITTER’S MANUAL ITEM NO.: 30113 INSTALLATION OF THE TRANSMITTER BATTERY’S SETUP Please use eight “AA” alkaline batteries or rechargeable batteries. First: In light of arrow’s direction, push the cover of battery case away, and lift it to sever the transmitter. Second: Insert eight batteries and pay attention to batteries’ anode and cathode. Third: push the cover of battery case to original place. Note: If using rechargeable batteries, you should use the intelligent charger(No.40108).
PAGE 2
EXPLANATION OF TRANSMITTER’S ANTENNA Before turning on the transmitter, you should ensure if the antenna is set up correctly, and is extended enough, Otherwise it will affect the range of control largely, possible cause damage to your model, or injuries yourself and someone else. INSTALLATION OF THE RECEIVER AND THE SERVO Before installation, please read these following instructions carefully in order to avoid the dispensiable loss to yourself and some else.
PAGE 3
8. Set the switch of the receiver to “ON” position. WARNING: 1. It is a electric set. Please never put it in the moist place to avoid from water entering. 2. Please observe the instructions on the manual strictly to operate or install this set. 3. If because of your wrong operation processes, it causes damage to the transmitter or injures yourself and somebody else, our company will not take responsibility for any loss on these problems. 4. Never mix the used and new battery up for use. 5.
PAGE 4
continusly, we only need ask for the new information and new product’s contents. We hope our best products of radio controller can make a lot of enjoyment in your life. FCC STATEMENT: “Modifications not authorized by the manufacturer may void users authority to operate this device” NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.