User manual
9
Operating your radio – FM
1. Press the Power On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. To scan up in frequency, rst rotate the Tuning control knob in a clockwise direction and then press
the Tuning control knob. Your radio will scan in an upwards direction (low frequency to high frequency)
and stop automatically when it nds a station of sufcient strength. To scan down in frequency, rst
rotate the Tuning control knob in a anti-clockwise direction and then press the Tuning control knob.
Your radio will scan in a downwards direction and stop automatically when it nds a station of sufcient
strength. After a few seconds the display will update. The display will show the frequency of the signal
found. If the signal is strong enough and there is RDS data present then the radio will display the
station name.
4. When the waveband end is reached, your radio will recommence tuning from the opposite waveband
end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
Manual tuning – FM
1. Press the Power On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. Rotate the Tuning control knob to tune to a station. The frequency will change in steps of 50 kHz.
When the waveband end is reached, the radio will recommence tuning from the opposite waveband
end.
4. Set the Volume Control to the required setting. To switch off your radio, press the Power On/Off button.
Display Modes – FM
On FM the bottom line of the display can be set to any of the following modes:
1. Press and release the Info button repeatedly to cycle through the various modes.
a. Radio text displays scrolling text messages such as artist/track name, phone in number etc.
b. Program type displays type of station being listened to e.g. Pop, Classic, News, etc.
c. Date displays the current date.
d. Frequency displays the frequency of the station being listened to.
Note:
If no RDS information is available, the radio will be unable to display the station name, scrolling
text and program type information.