User manual

Scan sensitivity setting – FM
The radio will normally scan all stations from FM broadcasts including the weaker
signals.However,youmaywishtheAuto-scantondonlythosestationswithstrong
enough signals to give good reception.
1. Press the On/Off button to turn on the radio.
2. Select the FM band by pressing the Source button.
3. Press the Menu button, the display shows “Scan setting”.
4. Press the Tuning knob.
5. Rotate the Tuning knob to select between “All stations” or “Strong station” (default
 is“Allstations”).The“Strongstation”optionwillallowtheradiotondstrongsignals
only when scanning.
6. Press the Tuning knobtoconrmyoursetting.Thedisplaywillreturntonormal
radio display.
PRESET STATIONS
Storing preset stations
There are 20 memory presets in the radio, 10 for DAB and 10 for FM. Presets are
remembered by the radio in the event of a power failure.
1. Press the On/Off button to turn on the radio.
2. Press the Source button to select the desired waveband.
3. Tune to the required station.
4. Press and hold the required Preset button until the radio beeps and shows “Saved”.
5. Repeat step 3 and 4 for the remaining presets.
6. Stations stored in the preset memories can be over-written by following the above
procedure.
Recalling preset stations
1. Press the On/Off button to turn on the radio.
2. Press the Source button to select the desired waveband.
3. BrieyPresstherequiredPreset button. In FM mode the display will show for
example ”P1” on top right hand side.
USING BLUETOOTH
Pairing Bluetooth with your mobile phone
1. Press the On/Off button to turn on the radio.
2. Select Bluetooth mode by pressing the Source button.
3. The blue Bluetooth connected LED on the front bar will be blinking when the
Handsfree radio is not yet paired with your mobile phone.
4. In your mobile phone open the Setting menu and select Bluetooth, then select “PP
Handsfree” in the Bluetooth devices list (Bluetooth pairing instructions may vary per
 typeofmobilephone,pleasecheckyourmobilephonemanual).
5. When Bluetooth pairing is successful, the Bluetooth connected LED will stop
blinking and the LCD display will show “Bluetooth Connected”.
Playing music from your mobile phone
1. Press the On/Off button to turn on the radio.
2. Select Bluetooth mode by pressing the Source button.
3. Start playing music by using the media players in the paired mobile phone.
4. Playback can be controlled from the mobile phone or by pressing the
, and
buttons(presetbuttons3,4and5)ontheHandsfreeradio.
Answering an incoming phone call from the Handsfree radio
The Hands-Free-Calling feature allows you to answer an incoming phone call when
operating in the Bluetooth, DAB, FM or AUX IN mode.
1. Press the Tuning knob (Phone icon) on the right to pick up an incoming call.
2. Speak towards the microphone located in the middle of the radio.
3. Adjust the conversation volume by turning the Volume knob. A lower volume setting
can reduce a possible echo in the phone conversation.
4. Press the Tuning knob (Phone icon) again to hang up the phone call.
Notes:ThevolumeoftheRingtonewillbeloudestfortherst20seconds,thenitwill
resume to the previous used level. Rotating the Volume knob or pressing the Tuning
knob (Phone icon) will also return the volume to the previous used level.
13 14
GB
GB