Manual

9
GETTING STARTED
Installation using THE "SET-UP WIZARD"
Place Perfectpro Rockpro on a flat surface and plug the AC power plug into the AC
mains power socket, be sure the voltage is correct.
IMPORTANT: In order to disconnect the Perfectpro Rockpro from the AC mains power
completely, the AC power plug should be removed from the AC mains power socket
completely and it shall remain readily operable and should not be obstructed during
intended use.
When you apply power, the display on the sound system will light up.
After a few seconds the radio will then enter Standby and the clock will display '00:00' as
shown.
To continue to setup Perfectpro Rockpro press the Power button. If this is the first
time that you use Perfectpro Rockpro (or after a Factory Reset) the display will show
'Setup wizard' and 'YES' will be highlighted on the screen.