Manual

12
When the sound system nds your wireless network, it displays the Network Name
(SSID) for the wireless access point on the screen. This is a name that is allocated to
the access point in your router by the person who set up the network - for example:
'Wilson' or 'Jame’s group'. If the router supports WiFi Protected Setup, then '[WPS]' will
be shown in front of the SSID.
It is possible, and in some locations highly likely, that Perfectpro Rockpro will find more
than one wireless network, in which case you should choose which one you need to
connect to.
Rotate the Tuning/Seek/Select control to see the SSID for each wireless network that
has been found. If your network is shown proceed to step 6. If it is not shown then
proceed to step 5.
If you make a mistake at any point, use the Back button to go back to the previous
screen.
If your network is not found, it may be because the router is configured not to
broadcast the SSID. You should then use the Tuning/Seek/Select control to highlight
and select the '[Manual config]' option in order to enter the network details manually.
This is described in 'Manual Network Configuration'.
If your network name is being broadcast, and it was not found, then try re-scanning
(press the Back button), and if necessary try moving Perfectpro Rockpro to a location
closer to your access point / router.
GB