Installation Guide

VINYL 4-IN-1
MOLDING INSTRUCTIONS
MOHAWK TECHNICAL SERVICES DEPARTMENT | 196 S. INDUSTRIAL BLVD. CALHOUN, GA 30701 | 888-387-9881 0066_2023 | MHS | 03/2023 | 1 OF 6
The Performance Accessories multifunctional 4-in-1 molding allows you to utilize a single transition to create four
different applications.
Please DO NOT discard the shims. Refer to the instructions for the specic prole you are installing for details on how to use the shims.
Refer to the installation instructions provided by the ooring manufacturer for required expansion spaces.
STEP 1 • REVIEW INSTALLATION CHECKLIST
• Inspect the moulding cover and track. Ensure that the channel on the moulding cover is uniform in width along the entire length.
• Do not push parts into track until ready to install in nal position.
• Do not remove from track once installed.
• Use a new 60–120 ne-tooth nishing saw blade for ooring for best cutting results.
• Use tin snips or a heavy duty cutting tool to cut the track and shims.
• Depending on moulding type, all parts may NOT be used.
• Always install screws in end holes of track and then every other hole.
• For concrete oors, drill hole using 3⁄16” (5mm) diameter concrete drill bit, insert plastic anchor, then use screw.
• Depending on the oor height, attach the shims or track directly to the suboor (remove any padding or underlayment).
• This product has been nished for you; do not sand or paint.
STEP 2 • CHOOSE YOUR TRANSITION TYPE
The kit allows assembly of four different molding options from one single product.
A. Carpet Transition
The carpet transition provides a smooth transition between your hard surface oor and carpet.
B. T-molding
The T-molding is used to transition between ooring of equal heights and in doorways.
C. End Molding
The end molding can be used to nish ooring where it meets vertical surfaces such as walls, replace hearths and
sliding glass doors.
D. Hard Surface Reducer
The hard surface reducer connects two oors of different heights.