Installation Guide
0721_LVF_MF_Install P.1
Vinyl 4-in-1 Molding Installation
The Performance Accessories 4-in-1 multifunctional molding with universal track
system uses integrated shims that can be cut o or folded under allowing this molding
transition to work with vinyl oors ranging from 2mm to 8mm in height.
Refer to the installation instructions provided by the ooring manufacturer for required
expansion spaces.
STEP 1
•
CHOOSE YOUR TRANSITION TYPE
Kit allows assembly of four dierent molding options from one single product
A. T-Molding
Transitions between hard surface oors of equal height
B. Carpet Transition
Finishes a hard surface oor where it meets carpet
C. Hard Surface Reducer
Transitions between hard surface oors of dierent heights
D. End Molding
Finishes a hard surface oor at sliding doors, replaces and other xed edges
STEP 2
•
INSTALL YOUR MOLDINGS
Each individual package includes the following:
Part #1 Part #2 Part #3
1. Measure and trim to t.
2. The universal shim is provided in one single piece. Follow the specic diagrams for
shim usage with your specic ooring height. The shim can be separated in three
places to create the 4 individual shims using a utility knife.
3. Staple, nail or glue track to suboor.
4. Line up cover with track and use rubber mallet to tap the track and cover together.