/2 In. Drive Twin Hammer Impact Wrench Composite Housing Stock Number M624 OWNER'S MANUAL FOR YOUR SAFETY, please read these instructions carefully and retain them for future use.
SPECIFICATIONS Bolt Capacity:............................ 9/16 in. Square Drive:............................... 1/2 in. Max. Torque (FT/LBS):.................... 230 Working Torque (FT/LBS):......... 50-200 Air Pressure (PSI):............................. 90 Avg. Air Consumption (CFM):............ 4 Free Speed (RPM).......................... 7800 Air Inlet (NPT):............................. 1/4 in. Hose Size (ID):............................. 3/8 in.
IMPORTANT SAFETY INFORMATION warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate any tool. 8. Be sure air is in OFF position when connecting tool to air supply. 9. Use only those accessories that are designed for use with tools. For example, with impact wrenches do not use ordinary sockets. Use impact sockets for all air tools. 10.
OPERATION 1. To set the tool to desired torque, select a nut or screw of known tightness of the same size, thread pitch and thread condition as those on the job. 2. Turn air regulator to low position, apply wrench to nut and gradually increase power (turn regulator to admit more air) until nut moves slightly in the direction it was originally set. The tool is now set to duplicate that tightness, note regulator setting for future use. 3.
LUBRICATION & MAINTENANCE Warning! Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in the air inlet is sufficient. Use proper air pressure and CFM rating listed for this tool. Drain water from hoses and compressor tank. Water in the air supply line will cause gumming and loss of power. Clean the air filter on the supply line and flush the tool with gum solvent or a 50/50 mix of air tool oil and kerosene.
REPLACEMENT PARTS LIST # Description Quantity 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 Hammer Case Grease Fitting Hammer Case Bushing Socket Retainer O-Ring 8X1.8 Standard Anvil Hammer Pin Hammer Hammer Frame End Plate Gasket Housing Rear Rotor Bearing Front End Plate Cylinder Throttle lever Pin 4X12 Rotor Blade Rotor Rear End Plate Rear Rotor Bearing Trigger O-Ring 3X1.
REPLACEMENT PARTS LIST 7
LIMITED WARRANTY PERFORMANCE TOOL® extends only the following warranties, and only to original retail purchasers. These warranties give specific legal rights. Except where prohibited by local law, the law of the State of Washington governs all warranties and all exclusions and limitations of warranties and remedies. There may be other rights which vary from state to state. PERFORMANCE TOOL® warrants the product to be free from defects in materials and workmanship under normal use and service.
