Use And Care Manual

5. ELEVATING & LOWERING HANDLE

Mount the blade elevation handle on the wheel

by tightening the screw in the handle (See Fig.

H).

6. MOUNTING THE RIP FENCE

Release the locking handle by pulling it upward.

Mount the rip fence onto the table so that the

side with the indicator is on the scale side of the

table (See Fig. I1).

Start by sliding the front of the rip fence onto the

front side of the table so that the front locking

plate contacts the front side of the table then

push down on the back of the rip fence so that

the fence is level on the table. Be sure front and

rear locking plates are in contact with both the

front and back edges of the table. (See Fig. I2)

7. ADJUSTMENT OF THE RIP FENCE



to be at 90° angle to the front side of the table.

If it is not at a 90° angle to the table, loosen the

two bolts (d) at the top front side of the rip fence



is at a 90° angle. (See Fig. J1)

Move the Rip Fence to contact the side of the

blade (the zero point) and then check that the

Rip Fence position indicator is on the “0” mark

on the scale. If it is not, loosen the screw (e) and

position the indicator on “0” and then retighten

the screw. (See Fig. J2)

NOTE: The Blade Guard and Splitter

will need to be removed to perform this

adjustment.