Use And Care Manual

15
OPERATION
1. ON/OFF SWITCH
WARNING! Before turning on the On/Off switch,
make sure the blade guard is correctly installed
and operating properly.
To start the table saw, depress the On/Off
switch to “I”.
To stop the table saw, depress the On/Off
switch to “O”.
2. BLADE ELEVATION HANDLE
The blade elevation handle is used to raise and
lower the saw blade. Rotate blade elevation
handle clockwise to lower the blade and
counter-clockwise to raise it (See Fig. L1, L2).
3. BLADE TILTING WHEEL
The blade tilting wheel is used to tilt the saw
blade for bevel cutting.
The stop collar locks the beveling mechanism in
the desired position.
When setting the angle of the cut, loosen the
stop collar by turning it counter-clockwise.
Rotate the blade tilting wheel and use the bevel
scale. Set the blade at the desired angle (See
Fig. M1). Tighten the stop collar by turning it
clockwise (See Fig. M2). Before turning the

securely tightened to prevent the blade from
shifting during operation.
d
J1
e
J2
K
L1
L2