Use And Care Manual
18
than “90”.
2) Set the bevel scale to the desired angle other
than “0°” using the blade tilting wheel.
Before using the table saw, make sure the
gauge and blade tilting wheel are locked.
9. RIPPING (SEE FIG. Q)
Ripping is cutting a piece of wood with the grain.
This is done using the Rip Fence.
Put the fence to the desired width of the rip cut
and lock it in place. Before starting to rip, make
sure:
1). Rip fence is parallel to the saw blade.
2). Splitter is properly aligned with the saw
blade. When ripping long boards or large
panels, always use a work-piece support. Hold
the material to be cut against the rip fence and
feed it through the blade with smooth, steady
pressure.
Only apply feed pressure to the work-piece
between the blade and the rip fence in order to
prevent the work-piece from binding against the
blade and causing kickback.
When ripping boards narrower than 6” (150
mm), use a push stick to feed the work-piece
until it is clear of the table.
Never rip freehand without the fence in place
and securely locked.
When bevel ripping material 6” (150 mm) or
narrower, use the rip fence on the right side of
the blade only.
10. SAWDUST COLLECTION (SEE FIG. R)
This table saw is equipped with a removable
sawdust collector. A dust collection system (sold
separately) can be attached to the dust port to
help remove sawdust from the work area.
To remove the sawdust collector, simply loosen
two nuts and remove the collector from the saw.
11. CHANGING THE SAW BLADE
WARNING:
Do not use for ferrous metals.
Donot use saw without proper guards.
Before each use, examine blade and tips for
cracks, breaking, missing or loose tips, or other
damage.
To remove the blade:
1) Remove the blade guard and the blade throat
plate.
2) Raise the blade to the highest possible position.
3) To keep the spindle from rotating, place the
the Wrench 2 on the nut and rotate the nut anti-
clockwise to loosen (See Fig. S1).
Q
Nut
(Tuerca)
Dust port
(Puerto de
polvo)
Sawdust collector
(Recolector de aserrín)
R
P4