Use And Care Manual

19
To install the blade, reverse the procedure.
IMPORTANT: Blade rotation is clockwise when
observing from the right side of the saw. Make
sure the install the blade with the right direction.
APPLICATIONS
CUTTING TIPS
1. Make sure the kerf is made on the scrap side of
the measuring line.
 
3. Always have a proper support for the wood as it
comes out of the blade.
4. Make a test cut for important cuts.
5. Always use the correct blade depth setting. The
top of the blade teeth should clear the top of the
material being cut by 1/8” (3 mm) to 1/4” (6 mm).
6. Inspect the work-piece for knots or nails before
beginning a cut. Remove any loose knots with a
hammer.
7. Always use clean, sharp, properly-set blades.
Never make a cut with a dull blade.
8. When making a cut, use steady, even pressure.
Never force a cut.
9. DO NOT cut wet or warped lumber.

hands or use a push stick or push block.
Maintenance
WARNING: Remove the plug from the
socket before carrying out any adjustment,
servicing or maintenance.
1). Keep tools sharp and clean for better and safer
performance. Inspect tool cords periodically and
if damaged, have repaired by authorized service
facility.
 
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
chemical cleaners to clean your power tool.
Wipe clean with a dry cloth.
3). Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust. If you see some

normal and will not damage your power tool.
4). If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent

any hazard.
S1
Wrench 1
Wrench 2
S2
S3