Use And Care Manual

8
and shape (diamond versus round) of
arbour holes. Saw blades that do not
match the mounting hardware of the saw
will run off-centre, causing loss of control.
h) Never use damaged or incorrect saw

saw blade washers, bolts or nuts. These
mounting means were specially designed
for your saw, for safe operation and
optimum performance.
i) Never stand on the table saw, do not use
it as a stepping stool. 
occur if the tool is tipped or if the cutting tool
is accidentally contacted.
j) Make sure that the saw blade is installed
to rotate in the proper direction. Do not
use grinding wheels, wire brushes, or
abrasive wheels on a table saw. Improper
saw blade installation or use of accessories
not recommended may cause serious

Symbol
Read the manual
Wear ear protection
Wear eye protection
Wear dust mask
Warning
Double insulation
Remove plug from mains before
maintenance or if cord is damaged.
Technical data
Voltage 120V~60Hz
Amps 15A
No load speed 4800/min
Blade size 10"(254mm)
Table size 22 1/5” * 22 1/3”
(563mm*567mm)
Extension table size 22 1/5” * 41 3/16”
(563mm*1046mm)
Max cutting depth at 45º 2"(50mm)
Max cutting depth at 90º 3"(75mm)
Right rip capacity 27” (686mm)
Left rip capacity 8 3/4"(222mm)
Weight 61.1lbs
Operating instructions
NOTE: Before using the tool, read the
instruction book carefully.
UNPACKING
WARNING: 
unexpected starting or electrical shock
during unpacking and setting up, do not plug
the power cord into a source of power. This
cord must remain unplugged whenever you are
working on the table saw.
Separate all parts from packing materials and
check each one with the illustration and the list
of Loose Parts to make certain all items are
accounted for before discarding any packing
material.
If any parts are missing, do not attempt to
assemble the table saw, plug in the power cord
or turn the switch on until the missing parts are
obtained and are installed correctly.
There are three positions on the machine
for different use, STANDING, FOLDING and
TRANSPORTING.
The legs are locked / unlocked by twisting leg
stand locking knob in desired holes or out of
the holes (See Fig. A1, A2).